Gardner Bender GGP-1502 Grounding Pigtail

You looking to find the "Gardner Bender GGP-1502 Grounding Pigtail" Good news! You can purchase Gardner Bender GGP-1502 Grounding Pigtail with secure price and compare to view update price on this product. And deals on this product is available only for limited time.

Price: $4.92 $0.75   

Product Feature

• For grounding-type receptacles, green insulation
• Variety of lengths and terminations fit any job requirement
• Captured screw and bare fork terminal ends
• 12 AWG stranded
• 8-Inch length

Product Description

"GARDNER BENDER INC" GROUNDING PIGTAIL12 AWGStranded copper grounding pigtail green insulation.Grounding screw pre-installed on one end.Opposing end has a spade terminal.Carded

Gardner Bender GGP-1502 Grounding Pigtail Review

I have changed my mind on this product because of the trouble I explain in the comments after this review.

The included green screws are Size 10 and 32 threads per inch. It would be wise to verify the size and threads of the installation area before trying to install this product. It is also an easy matter to tap the proper size and threads to match this product if you have a 10-32 tapping tool. I enjoy tapping my own installation holes, and this GB product actually showed me that I either forgot to tap a hole or I used the wrong thread when I tapped it, so I was able to make corrections immediately and install with no difficulty.

Some may not like the tight fit of the terinal lug on the screw. It may be intimidating, but you can use a little extra hand strength on the tool you provide to spin the screw in the terminal lug and it should be easy to install if the tapped hole and threads match the screw. The screw can actually be inserted and started by hand, with the tool used later to tighten down the wire in its final position. If there is difficulty in getting this screw to enter its installation hole, then there is likely a problem with your installation area size and thread count. If they all match the product, then the installation is very easy. All you do is turn the screw and it should draw itself into the hole with its threads.

Also, there may be some loss of the green color on the screw threads themselves, but I think it was designed that way.

I like the clean and shiny surfaces and the screws are made for either a nut driver or a phillips head screwdriver. I also like the length of this pigtail, which is more than enough for my work.

I purchased a large quantity of these because they were so inexpensive and I wanted to have a ready supply for electrical and computer projects.

Most of the consumer Reviews tell that the "Gardner Bender GGP-1502 Grounding Pigtail" are high quality item. You can read each testimony from consumers to find out cons and pros from Gardner Bender GGP-1502 Grounding Pigtail ...